Skip to content
OXODES

OXO Weld / Welding torch tracking

The arc strikes only at the right seam.

Two optical units follow the torch from both sides. Every seam is checked for place and order, and recorded.

The torch never leaves the picture.

A welding cell with two optical units on its frame, their fields of view drawn over the table, a stack light and the OXO screen.

Two optical units

The units look at the table from opposite sides, and their views overlap over the part.

A welding torch with a collar of three OXO tags around its neck, and the wire tip OXO tracks.

Three tags on the torch

Three OXO tags sit on a collar around the torch neck, 120° apart. However the torch turns, one faces a unit. OXO tracks the wire tip.

A welder leaning over the part, the body hiding the torch from one unit while the other still sees its tag.

Never out of sight

When the welder’s body hides the torch from one unit, the other still sees it.

How a seam is checked.

  1. Set the seams

    Each seam and its place in the order are set in the program. A new part is a new program, not a new fixture.

  2. Go to the next seam

    The screen shows which seam comes next, and OXO follows the wire tip to it.

  3. Wrong seam: no arc

    At any other seam the arc stays off. OXO keeps the power source’s enable signal off, the screen and the stack light turn red, and the right seam is shown.

  4. Right seam: weld

    At the right seam the arc strikes. The seam turns green on the screen and the next one is shown.

Every part, seam by seam, on record.

Each part leaves a record of the seams welded and the order they were welded in, with the operator and the time, like every OXO run.

The OXO screen after the last seam: six seams, all green, in the right order.

See OXO Weld on your part.

Send us a photograph of the part and the order its seams are welded in. We will show you how OXO Weld checks them.

Book a demonstration
Email
info@oxodes.com
Phone
+90 542 489 84 31